BENTLY136711-02输出模块

BENTLY NEVADA 136711-02 输出模块

BENTLY NEVADA 136711-02 输出模块

                                                      产品详情资料：

3500/33继电器模块

本特利3500/33十六通道继电器模块是一个全高度的模块，它可提供16个继电器的输出量。任何数量的16通道继电器模块，都可放置在框架接口模块右边的任一个槽位里。16通道继电器模块的每个输出，都可以独立编程，以执行所需要的表决逻辑。

每个应用在16通道继电器模块上的继电器，都具有“报警驱动逻辑”。该报警驱动逻辑可用“与门”和“或门”逻辑编程，并可利用框架中的任何监测器通道或任何监测器通道的组合所提供的报警输入(警告或危险)、非OK或独立PPL。该报警驱动逻辑应用框架组态软件编程，可满足应用中的特殊需要。

3500 16通道继电器模块

3300 XL NSv接近传感器系统包括：

bently3300 XL NSv探头

bently3300 XL NSv延长电缆

3bently3300 XL NSv前置器 

bently3300 XL NSv传感器系统主要用于埋头孔、侧视图或后视图限制限制使用标准Bently Nevada 3300和3300 XL 5和8 mm传感器系统的区域。它也适用于小目标应用，如测量轴的径向振动小于51毫米（2英寸）或轴向位置的扁平目标小于15毫米（0.6英寸）。它主要用于液膜轴承机器的以下应用中，其中存在小轴或缩小的侧视图。

径向振动和径向位置测量

轴向（推力）位置测量

转速表和零速测量

相位基准（键相信号）

                         产品英文详情资料：

3500/33 Relay Module

The Bentley 3500/33 sixteen channel relay module is a full height module that can provide an output of 16 relays. Any number of 16 channel relay modules can be placed in any slot on the right side of the frame interface module. Each output of the 16 channel relay module can be independently programmed to execute the required voting logic.

Each relay applied to a 16 channel relay module has an "alarm drive logic". The alarm drive logic can be programmed with "AND gate" and "OR gate" logic programming, and can use the alarm input (warning or danger), non OK or independent PPL provided by any monitor channel or any combination of monitor channels in the frame. The alarm driven logic application framework configuration software programming can meet special needs in applications.

3500 16 Channel Relay Module

The 3300 XL NSv Proximity Sensor System includes:

Bently3300 XL NSv Probe

Bently3300 XL NSv Extension Cable

3bently3300 XL NSv Proximitor

The bently3300 XL NSv sensor system is mainly used in areas where the use of standard Bently Nevada 3300 and 3300 XL 5 and 8 mm sensor systems is restricted by counterbore, side view, or rear view limitations. It is also suitable for small target applications, such as measuring shaft radial vibrations less than 51 millimeters (2 inches) or flat targets in axial positions less than 15 millimeters (0.6 inches). It is mainly used in the following applications of liquid film bearing machines, where there are small shafts or reduced side views.

Radial vibration and radial position measurement

Axial (thrust) position measurement

Tachometer and zero speed measurement

Phase reference (keyphase signal)

免责声明：

AMIKON我们销售新产品和停产产品，独立渠道购买此类特色产品。阿米控不是本网站特色产品的授权分销商、经销商或代表。本网站上使用的所有产品名称/产品图片、商标、品牌和徽标均为其各自所有者的财产。带有这些名称,图片、商标、品牌和徽标的产品描述、描写或销售仅用于识别目的，并不表示与任何权利持有人有任何关联或授权。